The plastic should be one coherent sheet.
Fusing plastic sheets together.
These can be made in arbitrary 2d shapes by using a soldering iron to fuse the edges of two plastic sheets together but it s obviously a pretty tedious and finicky process.
Polycarbonate is a clear colorless plastic often used as a replacement for glass.
If the plastic is sticking to the paper or if the plastic is forming holes your iron is too hot.
Plastic sheeting is notoriously hard to join tape is messy and glue won t stick.
Rob shows a clip of plastic laminating where heat fuses plastic to paper.
It is pretty simple to set up and only takes a few seconds to fuse the plastic together.
There are two ways to glue polycarbonate sheets.
Using epoxide glue for this purpose is a relatively simple procedure but fusing the sheets together is a little more interesting and can create a nearly invisible division.
Peel back the waxed paper to see how the plastic fusing is going.
I show how to use a soldering iron to fuse plastic together.
Using an epoxide or fusing the sheets together.
So there are too many different variables to give exact instructions.
Methylene chloride or chloroform.