Measure the roof of your shed.
Garden shed roof felting.
Watch our step by step video showing how to felt a shed roof with expert advice and top tips to help you complete the job with confidence.
Roll out the first layer of felt.
Cut the strips of felt roof to the right length using a knife including the 5cm overhang.
For most sheds you ll need to cut 3 pieces of felt.
The felt should overhang the end by around 5cm.
Shed roof felting replacing worn and split felt on the roof of a shed is essential if you want your tools and other garden equipment to stay in good condition.
First measure your shed along the bottom of the roof and up to the middle.
Http www fixmyroof co uk how to felt a shed roof in this video how to felt a shed part 2 we will be looking at how to fit felt to a shed roof and jus.
Also at the gable ends 7 5cm.
Clean and prepare the roof.
Remove old felt from the roof with your hands and a putty knife.
Buy the roof felt.
Pull it tight so that it lies flat on the shed roof.
Tack and secure the felt.
Some diy experience is handy but not essential.
Felting a shed roof isn t as difficult as it looks although you may want to enlist the help of a friend.
Grab loose pieces of felt and pull them off the roof with your hands.
When you are felting a sloped roof you start at the bottom and work your way up so that rain pours over the top of the laps and not under them.
How to felt a shed roof.
Allow for felt overhang.
Once measured and cut line the first piece of felt up so that it over hangs the edge of the roof on three sides by enough to cover the side pieces of the roof.
1 what you will need when felting a shed roof.
Pull out nails that are holding felt to the roof using the sharp end of a claw hammer.
Before installing the roofing felt measure the shed roof.
2 the process of felting a shed roof.
1 for each side of the roof as well as a third section that will overlap the 2 side panels by about 30cm on each side and run along the top ridge of the shed.
For pieces that aren t coming loose press a putty knife underneath it.
You ll need to cover the entire area of the roof with a little extra on each edge to allow for overlaps around 5cm.
Add new felt layers.